The Neon Bender's BBS!
The Archive no longer allows posting but search of hundreds of previous posts are available
If you have any questions please
contact us.
[Please Read]
|
Re: lead free glass
Posted By: SVP Neon Equipment In Response To: Re: lead free glass (Don Miner)
Date: Tuesday, 21 June 2011, at 12:26 a.m.
Have you tried flame annealing it on both sides of the seal immediately after you make the seal? With the lead-free you can use the appropriate big bushy flame without worrying about "smoking" the glass up.
> I have been doing 8 ' straight border tubes
> and had 5 out of 50 break about 1/8"
> from the weld. I clean the coating back from
> the factory end about 1/8". Make the
> weld, check for straightness, place tube on
> blocks above the bench. I have been doing
> them this way for 50 years and in the past
> three weeks, have had more weld breakage
> than in the past 50 years. I have talked
> with the people at EGL, and so far we have
> not been able the get to the root of it. Any
> thoughts? Thanks, Don
|
Neon Bender's BBS! is maintained by Kenny with WebBBS 5.12.
This page Copyright © 1996-2005 Krypton Neon